1. Remove brushes, turn off a nut and push the lever drive roller under the body panel.

2. Get a hatch cover in the right part of a forward partition.

3. Turn off bolts and get the electric motor, designate position of draft and disconnect draft, having arranged draft and the engine at right angle.

4. If necessary get draft via the hatch.

5. Installation is carried out upside-down.

1. Remove brushes, turn off a nut and push the lever drive roller under the body panel.

2. Carefully hook latches and remove ventilating panels (or one panel).

3. Turn off bolts and get the electric motor, disconnect draft.

4. Disconnect wires and remove the electric motor.

5. If necessary turn off bolts (nuts) of fastening of a plate of the roller and get draft assembled with the roller via the hatch.

Prevention Position of draft of the drive and electric motor of a cleaner is in advance adjusted therefore remove all drive only as a last resort, having marked a relative positioning of draft on the engine.

6. Installation is carried out upside-down.

7. Tighten nuts with m 5 N.' moment.